Thingiverse
Ceiling Mount Thule WingBar Evo
by tpo88
19
Downloads
18
Likes
0
Makes
This is my own version of "Car Roof Bar Rack Crossbars Mount by jschaftenaar".
It is basically the same idea but with following changes :
1) 4 screwholes intead of 2.
2) Base naworrer -adapted to my Thule's Wingbars Evo´s size.
3) Full piece a bit smaller due to limited bed size of my Ender 3 v2.
4) A little wider/stronger to compensate the fact that now is the piece is narrower.
4) Rounded / nicer edges.
On my Ender 3 v2 I had to remove the safe limits following this tutorial : https://www.youtube.com/watch?v=Il1sierB4Yk otherwise wasn't posible to print it flat.
Happy printing.
It is basically the same idea but with following changes :
1) 4 screwholes intead of 2.
2) Base naworrer -adapted to my Thule's Wingbars Evo´s size.
3) Full piece a bit smaller due to limited bed size of my Ender 3 v2.
4) A little wider/stronger to compensate the fact that now is the piece is narrower.
4) Rounded / nicer edges.
On my Ender 3 v2 I had to remove the safe limits following this tutorial : https://www.youtube.com/watch?v=Il1sierB4Yk otherwise wasn't posible to print it flat.
Happy printing.
tpo88 also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!