Thingiverse
Ceiling rose for light
door JaresB
0
Downloads
0
Likes
0
Makes
I built this rose to hide the cable and the hook of my bedroom light
It is made in two parts, rose and clamp.
The original rose is quite big, 10 cm diameter and 9 cm tall, as I had a lot of cable to hide and I didn't want to cut it out. I also made two alternative ones, a medium one (diameter 8 cm, height 7 cm) and a small one (diameter 8 cm, height 5 cm), but I didn't print them. All the roses simply rest on the clamp, no glue is needed or any other type of fitting.
The clamp itself holds thanks to a screw that is lightly tightened against the cable. I used a brass insert M3 sized melted into the plastic to be able to screw.
Printed with PLA and using support.
It is made in two parts, rose and clamp.
The original rose is quite big, 10 cm diameter and 9 cm tall, as I had a lot of cable to hide and I didn't want to cut it out. I also made two alternative ones, a medium one (diameter 8 cm, height 7 cm) and a small one (diameter 8 cm, height 5 cm), but I didn't print them. All the roses simply rest on the clamp, no glue is needed or any other type of fitting.
The clamp itself holds thanks to a screw that is lightly tightened against the cable. I used a brass insert M3 sized melted into the plastic to be able to screw.
Printed with PLA and using support.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
