Ceiling tile/display case transition cap for Amazon Raceway

A student organization here at the university needed caps for running ethernet cable and power through a cable chase from above the ceiling tile down to a display case. the kit didn't include the necessary trim pieces, so I whipped this up and printed a bunch for them. Slides right on to the existing latch geometry and closes the gap between the end of the chase and the face the wires punch through. steps out to clear the tile grid for easier install with no need to cut/bend the metal.

sucessfully printed in ABS and PLA with 0.4mm nozzle and 0.2mm layer heights.

Designed specifically for and tested with the amazon item linked below, however I have included the step file so you can modify it as necessary to fit whatever cable chase/raceway you need it for.

https://www.amazon.com/dp/B0BW328RV8?ref=cm_sw_r_cso_cp_apan_dp_6P5E6W8J1WBC5K44H7M5&ref_=cm_sw_r_cso_cp_apan_dp_6P5E6W8J1WBC5K44H7M5&social_share=cm_sw_r_cso_cp_apan_dp_6P5E6W8J1WBC5K44H7M5&titleSource=true&th=1