Celica 7th gen 'shift gate'

Some of my boot tabs were bent by the last owner so aftermarket leather boots never fit quite right.
So I took a shot at making my own.
Recommend printing face down and with a very low density support for the boot tray so that you can clear it easily. (for those of us that don't use pva filament)
Note: clean your old spray cans properly so you don't get it coming out in chunks. Or just wrap your print if you don't like the look of your bare filament.

Recommend using petg to prevent warping in summer heat, also gives slight flexibility to help with installation.

Future iterations will look at slimming down the gate so it's not such a gaping hole.

mk2: trimmed down the corners make installation easier.