Celica OEM camera mount

This is a 3D printed adapter designed to mount an original Toyota rear-view camera to the Celica T23 (7th gen).

The OEM Toyota camera plug is too long to fit in the Celica’s mounting spot, so the plug was removed and replaced with this adapter. It screws into place where the original plug would sit and includes a built-in cable channel for clean and secure wiring.

If desired, a seal for the cable channel can also be printed. It was designed for flexible materials such as 95A TPU (rubber/silicone-like), which allows some protection against dirt and moisture. While the seal might not be fully watertight, it should be adequate given the protected mounting location under the rear garnish.

Two versions of the adapter are available:
- 70° angle
- 80° angle

If you need a different viewing angle, feel free to request it. I can provide a version that suits your setup.

The adapter and camera are mounted using velcro tape, making it easy to install or reposition if necessary.