Slicer Discord
Cell Phone Mount – 3D-printbaar model van Thingiverse Thingiverse

Cell Phone Mount

door imtiaz
292 Downloads
231 Likes
2 Makes
Model downloaden
I created this cell phone mount to hold my phone (Nexus S) while I use it as a GPS or a speaker phone.

It clips to one of the bars on the vent, if the clip doesn't fit, the sketchup model is attached so you can make the modifications. The arms slide out so you can put your cellphone in, then they close and hold the cellphone in place. All the ports are accessible, so you can charge the phone while you drive or plug the headphone jack into your car speakers.

It works well on my Nexus S and my wife's Blackberry.

Enjoy...
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie