Thingiverse
Cell Structure Lamp 2
von JobSmolders
90
Downloads
88
Likes
1
Makes
A simple ambient light :-)
The light source is an Arduino Nano and 6 NeoPixels once again (the cheapest way to make an light source).
If you like to know more about these NeoPixels you can visit the AdaFruit website at : https://learn.adafruit.com/adafruit-neopixel-uberguide/arduino-library-use
I used an example of AdaFruit and modified it a bit. I just want the LED's to slowly change colors.
I included the sketch and the AdaFruit library in the ZIP file.
Also included a simple wiring diagram. The power supply is a phone charger (at least 1A)
The dimension of this lamp is 90x90x90 mm and printed in green PLA except for the diffuser.
The diffuser is printed in translucent PET-G. I have two types. A flat one and one that is printed using the “spiral outer contour mode”. You can see them side by side in one of the pictures. On this picture you can also see that I did not succeed printing the “spiral outer countour”one without warping. To prevent this more wall layers should be
The light source is an Arduino Nano and 6 NeoPixels once again (the cheapest way to make an light source).
If you like to know more about these NeoPixels you can visit the AdaFruit website at : https://learn.adafruit.com/adafruit-neopixel-uberguide/arduino-library-use
I used an example of AdaFruit and modified it a bit. I just want the LED's to slowly change colors.
I included the sketch and the AdaFruit library in the ZIP file.
Also included a simple wiring diagram. The power supply is a phone charger (at least 1A)
The dimension of this lamp is 90x90x90 mm and printed in green PLA except for the diffuser.
The diffuser is printed in translucent PET-G. I have two types. A flat one and one that is printed using the “spiral outer contour mode”. You can see them side by side in one of the pictures. On this picture you can also see that I did not succeed printing the “spiral outer countour”one without warping. To prevent this more wall layers should be
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
