Thingiverse
Cellphone stand
80
Download
110
Likes
0
Makes
Created this stand for my Galaxy Note 4. Since my cellphone+case is kinda big, chances are it will fit your cellphone.
If you want a cleaner fit for your larger or smaller cellphone.
Formula: (your cellphone's width)/86=New scale
Example, your cellphone is 70mm width. 70/86=0.81, so in cura, you will put a uniform 81% scale.
I used a 10mm brim when printed and generated a support for angles over 80.
(My cellphone is 86mm width, 160mm height, 13mm depth)
*Wires can pass under the stand since there is an angle*
If you want a cleaner fit for your larger or smaller cellphone.
Formula: (your cellphone's width)/86=New scale
Example, your cellphone is 70mm width. 70/86=0.81, so in cura, you will put a uniform 81% scale.
I used a 10mm brim when printed and generated a support for angles over 80.
(My cellphone is 86mm width, 160mm height, 13mm depth)
*Wires can pass under the stand since there is an angle*
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
