Center feed paper holder

I didn't like the over-sized monstrosity of a holder that was available for the small center feed paper roll (20cm wide, 12cm diameter) so I made my own. Smaller and, to my eyes at least, slightly nicer to look at, as far as paper holders go :)

The center body is cut from a 125mm PVC ventilation tube, used for going through e.g a bathroom wall I believe. I intended to glue the tube to the base but ended up only gluing the "teeth" to it.

The fit is rather loose, especially the lid. If you want to print this Thing then please check the dimensions of the tube you'll use and adjust the diameters of the base and the lid accordingly.