Thingiverse
Center Finder
door nach00
3
Downloads
2
Likes
0
Makes
Center finder with 1.5mm hole and keyring holder.
Available in 30mm to 130mm, in increments of 10mm
I tried to print a 0.5mm hole to accommodate a 0.5mm mechanical pencil, but the hole would get filled immediately during the printing process. the 1mm hole was still too small, so i have it set to 1.5mm, which is much smaller (enough to fit the pencil) after printing. Printed using ABS
Available in 30mm to 130mm, in increments of 10mm
I tried to print a 0.5mm hole to accommodate a 0.5mm mechanical pencil, but the hole would get filled immediately during the printing process. the 1mm hole was still too small, so i have it set to 1.5mm, which is much smaller (enough to fit the pencil) after printing. Printed using ABS
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!