Thingiverse
Center Speaker Stand
von christian_73f8e1
10
Downloads
7
Likes
0
Makes
Nothing fancy. You won't see much of this piece anyway.
Put recesses in the bottom to glue in rubber feet.
Size is 245 x 245 mm.
I printed with 8 % infill which is more than enough for the use case. Could go even lower.
Put recesses in the bottom to glue in rubber feet.
Size is 245 x 245 mm.
I printed with 8 % infill which is more than enough for the use case. Could go even lower.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
