Thingiverse
Ceramic Tile Jig
von wgreen92
104
Downloads
51
Likes
0
Makes
The orginal Tile Jig was too tight for my tiles, V2 has extended center clearance to 100.6 x 100.6mm testing now!
Work holding jig for a 4 inch (99.5mmx99.5mm) ceramic tile from Lowes for laser engraving.
Base is 10mm high, edges come up another 5 leaving 2mm of tile on top.
Can be screwed to wooden bed, using the 4- 5mm chamfered holes.
This work holding goes along with my Test Tile design. Burn the outer 110mmx110mm into your wooden bed, use that to align your jig to your machine.
Work holding jig for a 4 inch (99.5mmx99.5mm) ceramic tile from Lowes for laser engraving.
Base is 10mm high, edges come up another 5 leaving 2mm of tile on top.
Can be screwed to wooden bed, using the 4- 5mm chamfered holes.
This work holding goes along with my Test Tile design. Burn the outer 110mmx110mm into your wooden bed, use that to align your jig to your machine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!