Thingiverse
Certified True Copy stamper
door minidrifter
2
Downloads
2
Likes
0
Makes
DIY CTC stamper for office use.
Print the head using flexible filament, make sure your stringing is tuned out before printing. Should some stringing occur use a hot air blower tip to melt them.
The stamp has parts that slot in together, the head, the body and the handle, so it would be printable without supports. Just apply glue to the mating surfaces of the body and handle before assembly.
The head can be attached snug fit inside the body, though I would recommend using double sided tissue tape under the body to secure the head. That way should the head need to be replaced it can be peeled out.
Print the head using flexible filament, make sure your stringing is tuned out before printing. Should some stringing occur use a hot air blower tip to melt them.
The stamp has parts that slot in together, the head, the body and the handle, so it would be printable without supports. Just apply glue to the mating surfaces of the body and handle before assembly.
The head can be attached snug fit inside the body, though I would recommend using double sided tissue tape under the body to secure the head. That way should the head need to be replaced it can be peeled out.
minidrifter publiceert ook op
11 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!