Thingiverse
Cetus Enhanced Spool Holder
von Halloween24x7
4
Downloads
1
Likes
0
Makes
I like to have my spools sitting above my Cetus MKII 3D Printers so they take up less space. By doing this, I'm able to fit 4 side by side in a 2ft x 4ft area.
The spools don't spin well on the square aluminum extrusions, so I decided to print an rounded edge for the spool to ride on.
Print upright with the larger side down. I added sides to both ends to make it easier to keep sample filament from flopping off the end.
The spools don't spin well on the square aluminum extrusions, so I decided to print an rounded edge for the spool to ride on.
Print upright with the larger side down. I added sides to both ends to make it easier to keep sample filament from flopping off the end.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!