Cetus Head Cover

Cetus head cover

I want to attach parts to the head, but I do not want to break the genuine head, so I tried drawing from scratch. Compared to the original, the top was made 1 mm thick. Because the original looked weak. Then, the meaningless, 6 mm wasted hole was not reproduced.

The difficult part to assemble is the embedding of M3 nuts. It is easy to work with using M3's 20 mm long screw.

A version without rounding is for remodeling. If there is rounding, CAD operation is difficult.
enjoy it !

[Caution] If the stepping motor on the Z axis vibrates after replacement and can not be initialized, do as follows. Please exchange with the genuine head and check the output of screws.

[Caution] The upper M3 screw does not reach. Therefore, it is necessary to exchange it for a long screw. The length of the M3 screw is recommended to be 12 mm to 14 mm. The same design as a genuine product is possible, but it is necessary to use a long screw to increase the strength.