Cetus Printer z-axis security hook

this is to secure the z-axis after finishing the Print and also to have a good parking position while the printer is turned off

every thing beside the pin should be printed without support.

the goal was to make it fully printable - the screws that are needed are frome the spared screws that come with the printer - so you dont need anything else :)

the hook itself, i printed with full infill (maybe one setting lower would also work - but i just want to make sure its stabel :) )

the hammernuts should be printed with full infill - maybe you need to file them a bit to fitt better

the settings you see on the picture - the pin has to be rotated by 180° on the x or y axis.

the hoock_nut_position ist to help install the hammer nuts on the right position - the bar on top should rest on the z-axis top to get the right positions.

you should use vaseline on the shaft where the hook is insert in - also on the pin end