Cetus Z-Axis Stiffness Bracket

This bracket adds stiffness to extended Cetus printers primarily, but it might also be beneficial to standard height models. It holds the sprag bearing on the motor shaft to slow down a falling print head.

You have drill out 1 threaded M3 hole that was occupied by the rubber foot before. You might have to move the entire vertical aluminium extrusion slightly to get it to the correct height. Perform a bed calibration after installation.

Additionally you need:
* 3 M3 nuts DIN 934
* 2 M3x8 bolts DIN 912
* 1 M3x12 bolt DIN 912
* 3 mm drill