Cetus3D Feeder Guide 2.0

I have printed a few things using TPU on the Cetus with mixed results. Much too frequently I'd have failed prints because the TPU would bend and push sideways, out from between the feeder gear and the cold-end of the nozzle. My solution was to re-design the guide for the filament feeder so the gaps above and below the gear and guide are much, much smaller.

I'd recommend printing in ABS or nylon. The one I printed in PLA started to deform pretty quickly

* UPDATE: Printed it in Hatchbox Black ABS, and it's working wonderfully. I was having an issue with the PLA version bending a little bit. Not enough to cause any issues with prints, but it probably would have deformed more if I had kept using it. The ABS version is looking much better.