Cetus3D MKII Feeder Section

This is a remix of some other peoples previous attempt at fixing the Cetus3D extruder filament feeder issues, which I found didn't work well, or at all. Unfortunately the two designs I found are not exactly smart, as both of which push a bearing into the filament off-center, which I found causes the filament to wander or just plain be very difficult to feed properly - consistently. It's a simple concept, push the center of the filament against the center of the feed gear, from the center. Equal, 90 degree distribution of pressure to the filament = happy feeding.

The only materials you need to complete this print is an 3x7x3 bearing.

https://www.amazon.com/s/ref=nb_sb_noss?url=search-alias%3Dindustrial&field-keywords=3x7x3+bearing&rh=n%3A16310091%2Ck%3A3x7x3+bearing

DO NOT USE RAFTS ON THE T-HANDLE!!! Print it from the T-handle down, tip up.