cforms portable modular magnetic PLAYGROUND

cforms portable modular magnetic Playground for indoor and outdoor use The magnets built into the honeycomb ground plate are used to hold the magnetic feet at the bottom and as a magnetic surface at the top for optional accessories such as a card holder.   It consists of the following components, which require the following number of round magnets with a thickness of 3 mm and a diameter of 5 to max. 8 mm:   Honeycomb ground plate: 4x magnets 25mm feet: 1x magnet Case (Bottom and Lid): 12x magnets Dot: 1x magnet   The Playground is modular and can be assembled variably in length and width according to requirements, each of them has a usable playing area of 20 x 20 cm + 2 cm overhang, so that the following combinations have this size:   1 x 2 = 20 x 42 cm 1 x 3 = 20 x 62 cm 1 x 4 = 20 x 82 cm 2 x 2 = 40 x 42 cm 2 x 3 = 40 x 62 cm 2 x 4 = 40 x 82 cm 3 x 3 = 60 x 62 cm   The Playground Case fits 9x ground plates for a play area of approx. 62 cm x 60 cm, for which these parts are required:   9x ground plate 12x 4-way-connector 16x 25mm feet 1 x Case Bottom and Lid   This requires 64 magnets 8 x 3 or smaller (cost of 100 pieces approx. €12) During the printing of the parts with magnets, a pause is built into the profile at which the magnets (pay attention to the orientation!!!) are to be positioned in the printed part (the pause has to be at about a height of 3,40 mm).   Optionally, you can print an inlay in TPU so that the lid of the case serves as a cube base.   Further accessories will be published separately.   Lets PLAY designed by cforms