CH Yoke Table Mount Leg

Printed on Robo3d R1 ABS.
The nut is to tighten a standard bolt into the bottom of the CH yoke's foot holes if you get a 2nd hand yoke and they neglect to give you the mounting hardware.
The 6mm x 7.5cm Carriage bolt I used has a round head and a square tightening area under the head. (5/8ths 3xin) you may want 4in however if you have a thicker table. Just verify the one you buy has the correct threads to go into the bolts in the underside of the yoke.