Thingiverse
Chainsaw Cap Above Chain
por TJ_OVERKILL
0
Descargas
0
Likes
0
Makes
I lost the rubber cap that was above the chain on the chainsaw.
32mm ID
38mm OD
I printed in PETG so you have to take the side off to put it in and tighten it back up. But I had to change the chain as well so it worked out.
Ideally would be better if printed in TPU. But it works either way.
32mm ID
38mm OD
I printed in PETG so you have to take the side off to put it in and tighten it back up. But I had to change the chain as well so it worked out.
Ideally would be better if printed in TPU. But it works either way.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
