Thingiverse
Challenge box for kids
von i4get823
0
Downloads
1
Likes
0
Makes
This is a project I made for my grandson Wolf he is 31/2 and needs challenges.
The bottom and the posts have little dots on them to tell you where they go.
I printed the bolts at 100%
the walls at 15%
and the wrench at 50%
One of the pieces on the right side wall will need to be filled a little bit because it hits the post inside sorry.
The bottom and the posts have little dots on them to tell you where they go.
I printed the bolts at 100%
the walls at 15%
and the wrench at 50%
One of the pieces on the right side wall will need to be filled a little bit because it hits the post inside sorry.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!