Challenger Cup Holder Insert

Insert for the front cup holder of 2012 Dodge Challenger. Both cup slots are the same size, print 2 inserts. I could have added an extra 0.5mm but as is gives it a very good fit. If as I use it I find it creates a vacuum and wants to pull the insert up with the cup I may print again slightly larger for a friction fit or add some texture to the top to eliminate a vacuum. Will update the print if I find this to be an issue.

The little lift tab I designed onto it prints fine on my printer, slowing the layers down a little on the last few can help it turn out better. Really is not critical, just gives you something to grab onto with needle nose if it is stubborn to remove.

I printed with 20% infill however it is so thin it really does not have infill so this parameter should not matter.

Printed with TPU. A rigid material may need small size adjustments.