Thingiverse
Chamber Flag for 22LR
von kkrebs76
8
Downloads
8
Likes
0
Makes
Similar to the PCC Chamber Flag but sized for 22LR Cal. Trim the small build block off after printing. You can experiment on whether or not you need supports during printing.
Print using TPU for flexibility. The TPU will not melt in the chamber even after stages with a large round count.
Print using TPU for flexibility. The TPU will not melt in the chamber even after stages with a large round count.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
