Champion hueforge

IF YOU LIKE IT, LEAVE ME A BOOST LIKE AND A COMMENT WITH THE PHOTO OF THE PRINT, IT WOULD HELP ME A LOT TO KNOW IF YOU LIKE IT... It can be printed with any 3D printer. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x201.67mm in size  You may print at higher layer heights below the Min Depth of 0.48mm  The Max Depth is 2.2mm and the Actual Depth is 1.6mm Filaments Used: PLA Generic Recicled Black Transmission Distance: 0.3 PLA Generic Recicled Red Transmission Distance: 4 PLA Generic Recicled Yellow Transmission Distance: 6 This print uses 3 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Red At layer #12 (1.04mm) swap to Yellow At layer #16 (1.36mm) swap to Red This slider is set higher than the mesh depth. It is not affecting your final mesh. Consider removing it. At layer #17 (1.44mm) swap to Rojo for the rest.