Chandelier

This is fully* 3d printable chandelier.
* You will need E14 lampholders and 22AWG wires. They are not printable. :)

I used my things for this project:
http://www.thingiverse.com/thing:1292741
http://www.thingiverse.com/thing:1351085

Thee supports should be cut first from tubes in right angle. There is a step in diameter for reference.

Assembly:
1. Printed nuts should be glued to small domes
2. Small domes should be glued to three tubes
3. Install small ring (see notes below) on center tube and install big dome on it
4. Glue hook of your choice on center tube (see notes below)
5. Cut wires to appropriate legth and strip insulation
6. Tin ends of wires and connect them to lampholders
7. Slowly push wires in tubes and screw E14 lampholders into glued nuts
8. Install lampshade with E14 washers and fix by stock nut from lampholder
9. Fit assembled chandelier on ceiling and connect wires
10. Add E14 LED lamps by taste :)

That's it!

Notes:
You can select one of th