Charmander Pokemon Base

I made a lighted base for the Charmander model. The model has to be sized up 150% from the base STL file. This is important or the feet will not line up with the LEDs in the base. You will need to print four of the nut brackets. I used 8mm long M3 screws and nuts. The nuts should be glued in place in the recessed nut bracket, and then the nut bracket is glued into the 'Charmie Base Top'. There are channels for the brackets to perfectly fit to eliminate any guess work. I used three 5mm LEDs with 150 Ohm resistors powered by a 3V AA battery pack. The LEDs just slide right into the built in holders. I uploaded a base for Squirtle, and the window for the power switch is on the left side instead of the right. The base plates are interchangeable, so you can use whichever one your battery pack fits. I used some clear grip feet on the bottom so it will be off the screws and switch, and it won't slide around.