Thingiverse
Charnière / Hinge
por Pa39
156
Descargas
136
Likes
0
Makes
Here are 4 little hinges of different sizes:
20mm / 25mm / 30mm / 35mm (square)
No assembly ! you have to print them vertically (STL are ready to print), then they are immediately usable after print. You just have to "break" them before first use, it should not be so strong but be careful. Hinges are not designed for heavy weights, just use them for light weights.
- 20 and 25mm has to be used with M3 countersunk head screws.
- 30 and 35mm has to be used with M4 countersunk head screws.
Do not tighten the screws too strong, especially with PLA.
20mm / 25mm / 30mm / 35mm (square)
No assembly ! you have to print them vertically (STL are ready to print), then they are immediately usable after print. You just have to "break" them before first use, it should not be so strong but be careful. Hinges are not designed for heavy weights, just use them for light weights.
- 20 and 25mm has to be used with M3 countersunk head screws.
- 30 and 35mm has to be used with M4 countersunk head screws.
Do not tighten the screws too strong, especially with PLA.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
