Thingiverse
Chasing M2 ROV Graber Arm neutral Float
von Mjkkemper1
0
Downloads
0
Likes
0
Makes
Print two for each side
need foam tape of foam pad 1/8" to put on the inside of the arm to keep it from spinning
two 3mm x 1/2 SS bolts and nuts
need foam tape of foam pad 1/8" to put on the inside of the arm to keep it from spinning
two 3mm x 1/2 SS bolts and nuts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!