Thingiverse
Chef knife sheath
door Pondopholous
37
Downloads
27
Likes
0
Makes
This sheath was designed for a 19cm Oneida chef's knife. A raft or brim is recommended for successful printing, as the base of the model is very narrow (I used a 10mm brim). I printed it at 0.2mm resolution, but it should be fine at 0.3mm to speed up printing.
Pondopholous publiceert ook op
13 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
