Thingiverse
Chemex Filter Stand
von bencolt45
8
Downloads
10
Likes
0
Makes
I would greatly appreciate it if you went to see the updated version of this design at PrusaPrinters, thanks!
https://www.prusaprinters.org/prints/100167-chemex-filter-stand
-
-
-
-
A stand to hold Chemex coffee filters. Holds 20-25 filters at a time. Any square filter up to 150mm x 150mm will fit.
Printed on a Creality Ender 3. This could be printed standing up or on its side. Supports are recommended.
https://www.prusaprinters.org/prints/100167-chemex-filter-stand
-
-
-
-
A stand to hold Chemex coffee filters. Holds 20-25 filters at a time. Any square filter up to 150mm x 150mm will fit.
Printed on a Creality Ender 3. This could be printed standing up or on its side. Supports are recommended.
bencolt45 veröffentlicht auch auf
18 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!