Thingiverse
Chess Pawn
von Ljoxa
2
Downloads
6
Likes
0
Makes
A pawn I use as a bit of a test print.
Just make sure to use some support on that overhanging edge. You don't technically need a lot but the underside of it will look nicer the more you use. It's up to you how much you care. Also note that the underside is slightly concave so take that into account.
Just make sure to use some support on that overhanging edge. You don't technically need a lot but the underside of it will look nicer the more you use. It's up to you how much you care. Also note that the underside is slightly concave so take that into account.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
