Slicer Discord
Chevy SS Source Wheel Lever II – 3D-Druckmodell von Thingiverse Thingiverse

Chevy SS Source Wheel Lever II

von c4b4the04
1 Downloads
0 Likes
0 Makes
Zum Modell
On the Chevy SS, the entertainment system has a selector wheel on the right side of the steering controls. The wheel has the letters SRC that can be pushed up, down or in. The wheel is difficult to turn and there isn't a protrusion or lever to help you with inputs.

This part will replace the small SRC letters without damage or any permanent modification to your switch. Simply follow the directions for removing the airbag (plenty of tutorials on ssforums or youtube), remove the multifunction switch and then disassemble. Total time for this mod is about 30 minutes but is very low cost and fits quite well.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen