Thingiverse
Chevy Volt lifter combined
di TheAdmrl
16
Download
15
Likes
0
Makes
This is not the holder.. These are needed to hold up the Chevy Volt iPhone holder on this link: http://www.thingiverse.com/thing:2227364
The forks fit very tightly into the holder and probably will need sanding to fit. A tight fit is important to insure everything stays in place.
The wings on these legs are very thin. They are made to slide into the trim seam on the volt. There is a raised side that will keep them from sliding completely into the seam and getting lost.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/2yP0UkxTy1R
The forks fit very tightly into the holder and probably will need sanding to fit. A tight fit is important to insure everything stays in place.
The wings on these legs are very thin. They are made to slide into the trim seam on the volt. There is a raised side that will keep them from sliding completely into the seam and getting lost.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/2yP0UkxTy1R
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
