Chick Feeder

A chick/bird feeder. Designed because the store bought ones are too large for the container with just 4 chicks. Has a screw on lid.Two sizes:Small: 112mm round, 77mm tall (without cap)Medium: 150mm round, 102mm tall (without cap)Recommend using ASA and keeping it away from any heat sources. PLA is not recommended if you have it anywhere near a heat source. Plate 1: BasePlate 2: CapPlate 3: Ball Cap (as ours were using the cap to get higher and get out of the container this one should make it a little more difficult)Plate 4: Guard (this should reduce some of the junk they get in and keep some of the food in - they are messy) Other Chick 3D Prints:Chick Roost: https://makerworld.com/en/models/1347761-chick-roost#profileId-1389819Chick Waterer: https://makerworld.com/en/models/1339345-chick-waterer#profileId-1379533