Thingiverse
Chicken Feeder
von hassebjork
44
Downloads
32
Likes
0
Makes
I designed a chicken feeder, made from a 110 mm tubing with a 75 mm Y-connector, where the chicken could peck their seeds. A few birds threw the seeds on the ground and started picking them from there. Sometimes they emptied the whole tube of a few kilograms.
To put an end to this, I designed this part which stopped them from, being able to fling the seeds around, and spreading them all over the place.
It is made of 2-3 mm PETG, with extra enforcement around the edges. The tube put into the feeder is slightly conical 74-76 mm for a nice fit into 75 mm tubing.
In the photo, there are a few iterations, the early ones being too deep. It might be too narrow for a rooster with a big comb.
The source file is made with FreeCAD.
To put an end to this, I designed this part which stopped them from, being able to fling the seeds around, and spreading them all over the place.
It is made of 2-3 mm PETG, with extra enforcement around the edges. The tube put into the feeder is slightly conical 74-76 mm for a nice fit into 75 mm tubing.
In the photo, there are a few iterations, the early ones being too deep. It might be too narrow for a rooster with a big comb.
The source file is made with FreeCAD.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
