Thingiverse
Chicken Trophy
von Julius3E8
269
Downloads
256
Likes
3
Makes
This is a set of trophies that I made for a chicken wing cook-off event to be handed out to the top three competitors.
As presented in these stl files, they are kind of small - a mere 25mm along one base edge and about 45mm high, so you may consider a scale factor of 1.5 if you want them to have any kind of heft (or at least be large enough to show up in winner-pose photos).
They can be printed without any raft or support.
If you found this useful, please share your work and be sure to peruse my other submissions which are almost as varied as they are many:
http://www.thingiverse.com/3E8/designs
BAGAWK!!
As presented in these stl files, they are kind of small - a mere 25mm along one base edge and about 45mm high, so you may consider a scale factor of 1.5 if you want them to have any kind of heft (or at least be large enough to show up in winner-pose photos).
They can be printed without any raft or support.
If you found this useful, please share your work and be sure to peruse my other submissions which are almost as varied as they are many:
http://www.thingiverse.com/3E8/designs
BAGAWK!!
Julius3E8 veröffentlicht auch auf
339 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
