MakerWorld
Board Games
Zum Modell
children's dice
6
Downloads
11
Likes
3
Makes
Hello 3D printing friends, I would like to welcome you to my printing profile. I have been creating developmental toys for my little daughter again, so I thought I would share it with you.I hope you like my model.If so, please leave a like or you can support my model with boosters. If you are satisfied with my model, check out my other models on my profile. I used 6x4mm magnets to attach the lid of the cube. The hole is prepared with a diameter of 6mm and a depth of 4mm. This is to prevent various shapes from falling out when the baby plays, not to wear it out. Or you have to choose stronger magnets.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
