Chip Bag Clip - 2 Sizes

Important: PLA is not recommended for the spring part of this clip. PLA may work initially, but will likely fail in a short amount of time. This was made and tested using a PETG spring. Other materials with low creep may also work, such as ASA or ABS, but I haven't tested either. Printing the body from PLA and the spring from PETG yielded the best results for me. Printing it entirely from PETG will function fine, but the PETG is more prone to creaking noises. Adding a small amount of grease on the hinge (2 points pictured) solved the creaking with PETG for me. Assembly is quick but will require some force to press the spring into place. The amount of force needed can vary depending on your specific filament and printer. I tried to find a good middle ground that hopefully won't be too difficult for most to install, while also retaining sufficient clamping force.Any support/follows is greatly appreciated!