Thingiverse
Chip Clip w/Magnet!
door MagicalBeard
3
Downloads
1
Likes
0
Makes
Remix of the chip cliv V3 by @dav88 to add a hole for a 2x6mm magnet! Its just a tad larger than the original to support the magnet.
I designed the hole with a 0.2mm tolerance and was able to pressure fit the magnet in the hole without gluing, if you have better tolerances than I you may need to use a small dab of superglue.
I designed the hole with a 0.2mm tolerance and was able to pressure fit the magnet in the hole without gluing, if you have better tolerances than I you may need to use a small dab of superglue.
MagicalBeard publiceert ook op
11 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
