ChipClip Crocodile

I don't like the clips bouncing around the house, because I can't find them when I need them. so I decided to make a stand not only to store them but also to display them, and now they can even be on display somewhere in the kitchen as decor while you need them. The union between faces and body is based on pressure, so the clearances are quite tight and will depend on the calibration of your printer. I made a test model so you can check before printing the full body: print just a "duck face" and "body test" to test fit and scale as needed between 99% and 101% in 0.5% increments In total you need to print 3-“face” and 1-“body ” to print I used Material: PLA/PETG Layer height: 0.28 Nozzle diameter: 0.4 or 0.6 Infill: 12-15 Perimeters: 2 Supports: NO, as long as it is printed in the orientation I show in the images Printing time: about 2 hours (not counting the test) Amount of material: about 22 grams (not counting the test) I uploaded two sizes, one for little clips that you can use with