Thingiverse
Chonky Headphone Stand
door MoltenCucumber
0
Downloads
2
Likes
0
Makes
Made in Fusion 360
My headphones are pretty big (Beyerdynamic DT770) and most headphones stands are too small so the cable was torqued at an odd angle against my tabletop. This was designed to be **chonky** - hence the name - and hold any headphones of any size.
On the off chance that you want your headphones even higher off the surface, there are included feet which should fit nicely into the 6 holes on the bottom. The listed height is the height of their protrusion out of the holes, so they will be ~14mm longer than named. If the fit is too tight, low grit sand paper (
My headphones are pretty big (Beyerdynamic DT770) and most headphones stands are too small so the cable was torqued at an odd angle against my tabletop. This was designed to be **chonky** - hence the name - and hold any headphones of any size.
On the off chance that you want your headphones even higher off the surface, there are included feet which should fit nicely into the 6 holes on the bottom. The listed height is the height of their protrusion out of the holes, so they will be ~14mm longer than named. If the fit is too tight, low grit sand paper (
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
