Chopper -One Piece

Chopper is based on an incidental character from the 'One Piece' anime series. Chopper stand approximately 60mm tall, depicted in a neutral stance. I created this model several years ago, after building my 1st 3d printer. I was still learning how and what worked best back then, but this model printed well, even though I built a printer using a DIY kit, with limited instruction. I made this for a fan of the show, so I don't think I've ever posted it until now. The model comes with a simple detached base. Use epoxy, resin, or glue to attach Chopper or make your own base.The model will need some supports for the chin, hat and probably the overhanging horns. Other than that, it should print cleanly. Be careful of the legs, as they are quite thin relative to the rest of the body. I have thickened them a bit to strengthen them as they connect to the pants, without deviating too far from the character design.Suggested Print Settings- Print using 0.1 to 0.2 layer height, with at least 15% infill- Set wall count to at least 2, with 10 to 20% overlap for strength