Thingiverse
Christmas ball, LED
por ecolio314
1
Descargas
1
Likes
0
Makes
Half Christmas ball design with groove for the wire and a central ring to centre LED.
Printed by half, single wall with no infill.
It does not require support.
You can play on the material transparency and outer wall quality (fuzzy skin in cura, perimeter numbers and thickness,...)
In my project, i used 5V LED strip, 2 led in each ball, connected on a white electric cable.
for strength, the 5V cable was not cut, the insulator was etched off and the LED soldered to it with 1cm wires soldered on the led strip. once assemble , the 2 half were glued together using super glue.
Enjoy!
Printed by half, single wall with no infill.
It does not require support.
You can play on the material transparency and outer wall quality (fuzzy skin in cura, perimeter numbers and thickness,...)
In my project, i used 5V LED strip, 2 led in each ball, connected on a white electric cable.
for strength, the 5V cable was not cut, the insulator was etched off and the LED soldered to it with 1cm wires soldered on the led strip. once assemble , the 2 half were glued together using super glue.
Enjoy!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!