MakerWorld
Gadgets
Zum Modell
Christmas decoration
32
Downloads
29
Likes
2
Makes
parts neededWhite PLA or PETGGlueBatteriesWhite lights with battery holder (I used these)2mm foamAssemblyMake 3 rectangles of 2x1 cm from the foam and stick them as in the photo. Take the lights and put them through the hole and press the battery holder in place.   2. Press the middle tree (2) into its slot and use hot glue to hang the light on it. It should         look something like this. Note that for the best result you should orientate the lights           towards the tree. I did not use all 20 lights, I cut the rest.   3. Press the small tree (3) and the deer (5) into its slot and glue the big tree (1) to the back.       then it should be ready.If there are any problems, send me a message and I will do my best to help. Good luck and have fun printing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
