Thingiverse
Christmas Light Earrings
by cncspartan
308
Downloads
362
Likes
0
Makes
Another pair of Christmas Earrings i made for my wife.
Earrings are 20mm x 20mm x 40mm and can be scaled up or down for a smaller earring, or use as an ornament.
With such a small part being on the build plate I would definitely suggest using a brim - especially if you program a filament change where the screw part of the bulb begins - i switched filament at layer 162 @ .2 layer height.
I have printed these from 0% to 100% infill - 2 walls are more than sufficient.
Earrings are 20mm x 20mm x 40mm and can be scaled up or down for a smaller earring, or use as an ornament.
With such a small part being on the build plate I would definitely suggest using a brim - especially if you program a filament change where the screw part of the bulb begins - i switched filament at layer 162 @ .2 layer height.
I have printed these from 0% to 100% infill - 2 walls are more than sufficient.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!