Thingiverse
Christmas Snowman
door Grantbaxter
16
Downloads
8
Likes
0
Makes
Fairly large snowman for Christmas decorations.
Height is approximately 25cm (just an eyeball measurement) when assembled.
Comes in 8 parts (please note the hat and nose will need supports).
I used a bit of blue tack to secure some parts but guess you could use super glue.
Printed mine at 0.2mm with minimal infill on the body (5% or so), a bit higher on the small bits (30-40%).
Hope you guys like it.
Height is approximately 25cm (just an eyeball measurement) when assembled.
Comes in 8 parts (please note the hat and nose will need supports).
I used a bit of blue tack to secure some parts but guess you could use super glue.
Printed mine at 0.2mm with minimal infill on the body (5% or so), a bit higher on the small bits (30-40%).
Hope you guys like it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
