Thingiverse
Christmas stensils
von SteffenLL
15
Downloads
7
Likes
0
Makes
This is remixed from several thingiverse files where i just added some minor changes to make a stensil out of it.
These were made in a hurry therefore the scaling is all over the place. To get em right (Cura slicer) turn of uniform scaling and scale x and y to a desired size, then scale z to atleast 2mm below that they will be a bit to flimsy.
To bend the handle like in the picture place the stensil on a table with the handle outside and gently heat it up on both sides. Dont heat the stensil, since the smaller part can curl upwards
These were made in a hurry therefore the scaling is all over the place. To get em right (Cura slicer) turn of uniform scaling and scale x and y to a desired size, then scale z to atleast 2mm below that they will be a bit to flimsy.
To bend the handle like in the picture place the stensil on a table with the handle outside and gently heat it up on both sides. Dont heat the stensil, since the smaller part can curl upwards
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
