Christmas Tap Handle
door TurtleOverlord
26
Downloads
12
Likes
0
Makes
Christmas/Winter themed handle for keg tap.
My program exported it in high quality, so it takes a minute to load in.
I printed at 0.1mm layer height with supports (touching build plate).
I'm not sure of the effect of layer thickness on the threads.
I removed the base of,
https://www.thingiverse.com/thing:2722279
added threads, and elongated it a little so it was taller.
Threads were a little tight but if you go slow and back out a few times it should be fine.
Maybe use pliers with a cloth or tape so you don't scratch it too bad.
My program exported it in high quality, so it takes a minute to load in.
I printed at 0.1mm layer height with supports (touching build plate).
I'm not sure of the effect of layer thickness on the threads.
I removed the base of,
https://www.thingiverse.com/thing:2722279
added threads, and elongated it a little so it was taller.
Threads were a little tight but if you go slow and back out a few times it should be fine.
Maybe use pliers with a cloth or tape so you don't scratch it too bad.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!